I'm pretty new to the world of cisco so please excuse me. My company have recently bought a lot of cisco equipment, including 3508, 3550, 2620 router and some other switches. We have setup VLAN's and all is working very well, thanks to all your postings but we have a piece of software that distributes desktop builds using multicasting but i seem to be having a real problem understanding it. Is there a easy way of configuring it (an idiot's guide)?
Multicasting is an advanced and complex topic and I do not think that one small guide can help you here. I am providing the link to the cisco's support page on Multicast where it has lot of useful articles on multicast. Take some time to read these articles. May be this is a good place to start.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...