Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Multichannel ports STM-1 and 8E1 and clns protocol

Hi,

We are installing a new customer network with 7204VXR routers, customer is running IP and OSI protocols.

We have a PA-MC-STM-1 and the only info I have found on CCO tell about only IP and IPX can be configured. Has anyone configured CLNS over STM-1 card?

Regards and thanks

1 REPLY
New Member

Re: Multichannel ports STM-1 and 8E1 and clns protocol

I do not see any reason why you cannot configure CLNS on a particular i/f assuming it is supported on the other interfaces.

83
Views
0
Helpful
1
Replies
CreatePlease to create content