Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

MultiLayer Switching

I was wondering if it was possible to do multilayer switching with my 4006 switch w/ Sup II engine and an external 3640 router.

  • Other Network Infrastructure Subjects
2 REPLIES
Cisco Employee

Re: MultiLayer Switching

No you cannot. MLS is not supported on Supervisor1/2 for CAT400x

New Member

Re: MultiLayer Switching

Thats what I've heard, but then I issue the show mls command and get back a response.

Total packets switched = 0

Total Active MLS entries = 0

IP Multilayer switching enabled

IP Multilayer switching aging time = 256 seconds

IP Multilayer switching fast aging time = 0 seconds, packet threshold = 0

IP Current flow mask is ??? flow

Configured flow mask is Destination flow

Active IP MLS entries = 0

Netflow Data Export disabled

Netflow Data Export port/host is not configured.

Total packets exported = 0

IP MLS-RP IP MLS-RP ID XTAG MLS-RP MAC-Vlans

---------------- ------------ ---- ---------------------------------

135
Views
0
Helpful
2
Replies