Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Multilayer Switching

I have a 5000 switch with a supervisor III & NFFC II card and a 4500-M router with a NP-1FE. Following the BCMSN book, I can not assign vlans "interface vlan X" command is not available????.

show version on 4000:

4000_router>show version

Cisco Internetwork Operating System Software

IOS (tm) 4500 Software (C4500-A3JK8S-M), Version 12.2(10a), RELEASE SOFTWARE (fc

1)

Copyright (c) 1986-2002 by cisco Systems, Inc.

Compiled Mon 20-May-02 14:42 by pwade

Image text-base: 0x60008948, data-base: 0x6120C000

ROM: System Bootstrap, Version 5.3(16) [richardd 16], RELEASE SOFTWARE (fc1)

BOOTLDR: 4500 Software (C4500-BOOT-M), Version 12.2(7c), RELEASE SOFTWARE (fc1)

4000_router uptime is 1 hour, 26 minutes

System returned to ROM by reload at 11:35:18 UTC Sat Mar 29 1997

System image file is "flash:c4500-a3jk8s-mz.122-10a.bin"

cisco 4500 (R4K) processor (revision E) with 32768K/16384K bytes of memory.

Processor board ID 07371420

R4700 CPU at 100Mhz, Implementation 33, Rev 1.0

G.703/E1 software, Version 1.0.

Bridging software.

X.25 software, Version 3.0.0.

SuperLAT software (copyright 1990 by Meridian Technology Corp).

TN3270 Emulation software.

1 FastEthernet/IEEE 802.3 interface(s)

128K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (Read/Write)

4096K bytes of processor board Boot flash (Read/Write)

Configuration register is 0x2102

4000_router>

version on 5000:

5000_switch> show version

WS-C5000 Software, Version McpSW: 4.5(1) NmpSW: 4.5(1)

Copyright (c) 1995-1999 by Cisco Systems

NMP S/W compiled on Mar 29 1999, 16:09:01

MCP S/W compiled on Mar 29 1999, 16:06:50

System Bootstrap Version: 5.1(2)

Hardware Version: 3.4 Model: WS-C5000 Serial #: 014358995

Mod Port Model Serial # Versions

--- ---- ---------- --------- ----------------------------------------

1 4 WS-X5530 014358995 Hw : 3.4

Fw : 5.1(2)

Fw1: 4.4(1)

Sw : 4.5(1)

2 12 WS-X5213 003613583 Hw : 1.3

Fw : 1.4

Sw : 4.5(1)

DRAM FLASH NVRAM

Module Total Used Free Total Used Free Total Used Free

------ ------- ------- ------- ------- ------- ------- ----- ----- -----

1 32640K 13621K 19019K 8192K 4118K 4074K 512K 113K 399K

Uptime is 0 day, 9 hours, 7 minutes

5000_switch>

1 REPLY
Bronze

Re: Multilayer Switching

For inter-vlan routing using external routers, you have to create subinterfaces. Check out the link below:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_5_2/layer3/routing.htm#37431

Hope that helps.

71
Views
0
Helpful
1
Replies
CreatePlease to create content