Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Multilink of T1 and fractional T1 on 3640 and 7206

Is it possible to take a full T1 on one serial interface and 15 channels of a T1 on another serial interface and link them with a multilink interface on a 3640 and a 7206? If not, is CEF load balancing my only other option to combine the bandwidth?

Thanks.

2 REPLIES
New Member

Re: Multilink of T1 and fractional T1 on 3640 and 7206

what routing protocol, with eigrp or igrp could use unequal cost load balancing by setting a variance.

New Member

Re: Multilink of T1 and fractional T1 on 3640 and 7206

EIGRP. How would you do that? Set up two different IP addresses? This is an acceptable alternative, although I was hoping multilink was possible so I could treat it as one interface with one address.

149
Views
0
Helpful
2
Replies
CreatePlease login to create content