Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Multilink PPP with 2 x E1 - dropping link

I have an MLPPP bundle of two E1s. One E1 is dropping from the MLPPP bundle about every 1 hour because of the follwoing error message: Lost fragment timeout and then Request drop link from bundle.

Shortly afterwards, the link comes backup and is taking traffic again. Could this be due to bad line quality, clocking issue? I hardly have any errors on the line. Anybody some similar experience?

thanks,

Florian

1 REPLY

Re: Multilink PPP with 2 x E1 - dropping link

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

249
Views
0
Helpful
1
Replies