Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Multilink PPP

I currently have about 25 sites that use ISDN backup. Everything worked fine up until I upgraded the IOS on the 3662 dialin router from 12.2.11T to 12.3.7T. Now, when a remote site dials in on ISDN, they get connected but you can't ping across the link and I don't see IPCP inserting a route onto the remote router during a debug. If I remove the "ppp multilink" command from both the BRI and Dialer interfaces on the remote routers, they connect fine and you can ping across. The second B channel will come up also, however, without using "ppp multilink" the channels are not bound together to give me the 128K.

Anyone have any ideas because I have been racking my brain for a while on this one adding and removing commands to see what would fix the problem.

Thanks!

Michael

2 REPLIES
Bronze

Re: Multilink PPP

You should probably open up a TAC case as this could be some new IOS bug. If you want to post interface (BRI/serial0:23/dialer) level config from the 3662 and one of the remotes along with debug dialer, debug ppp nego, debug ppp chap and debug ppp multilink from the same remote, I could take a quick look at it.

~Zulfi

New Member

Re: Multilink PPP

I'm probably indeed will have to open a TAC case. I already did the debugs and during the ppp negotiation it comes up saying "lower layer not available" and doesn't insert the router during IPCP.

100
Views
0
Helpful
2
Replies