I want to be able to provide load balancing across multiple serial circuits using PPP encapsulation in either a single router or dual router scenario. I have read the MPPP and MMPPP information published on CCO. Will either of these technologies support serial T1 communications? Any recommendations on MPPP vs. MMPPP would be appreciated.
Yes, MPPP will work with T1's.... see http://www.cisco.com/warp/public/129/15.html and I'm pretty sure (scanning CCO) that MMPPP will also but I'm not too familiar with MMPPP. If guess if you have more than one router on one side, you may go for MMPPP.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...