I am interfacing 2 ABR's to a microwave management network configured as Area1 and all of the nodes in Area1 are configured as stubby. The fact that there are multiple ABR's, is there any concern with routers in Area 0 seeing routes to other Area0 networks via the Area 1 network? Basically I am concerned that Area 0 traffic may traverse the Area 1 stub network (area0-area0). My understanding to this point is that a stubby area (area1) will not advertise any other areas so does this mean that Area 1 will only see default routes to Area 0 but Area 0 will not see Area1 as an option to route Area0 to Area0 traffic?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...