Unless otherwise specified, the "standby track" will only drop your priority by 10 points... in your case, not enough to cause a failover.
Also, in order to use track, you need to use "preempt" so that when a priority *becomes* higher, it can preempt control. "preempt" is associated to a group so you would need to say "standby 1 preempt". The way you have it assignes preempt to group 0 and does not affect your config.
Also, unless you're load balancing, you can use "standby ip address x.x.x.x secondary" instead of creating multiple groups.
I would change your priorities to default for standby (100) and 105 for active. This will allow track to work with no changes.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.