Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Multiple ISP access via ATM Cisco 5500 Catalyst

I have four (4) local ISP providers connected to the Government network. Each ISP Provider was provided

a DSL Ethernet (4M) connection to Site A Catalyst 5500 ATM DS3. Each ISP have a unique PVC on the Site A Catalyst 5500.

Currently Site A Catalyst 5500 have only one (1) defauflt gateway. The Site A Catalyst is connected to Site B Catalyst 5500 via a DS3 ATM.

The Site B Catalyst 5500 has forty (40) departments connected via a DSL Ethernet 4M with a unique PVC.

The department has the option to select any of the four (4) ISP provider connected on Site A Catalyst 5500 for its Internet access.

Since the Site A Catalyst 5500 has only one default gateway, how can I route internet traffic to selected ISP provider per each departments requirement. Each department has its assigned IP Address block. The department could route their

entire IP address or selected IP address only.

1 REPLY

Re: Multiple ISP access via ATM Cisco 5500 Catalyst

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

126
Views
0
Helpful
1
Replies
CreatePlease to create content