I administer five development networks and one admin network. The admin network connects all five development networks using a Cisco 7513 router. Access lists prevent the development networks from seeing each other.
Each development network has approx 180 hosts and consists of 17 LANS. All hostnames are the same between development networks but IP addresses are currently different.
In about one month, all development networks will use the same IP addresses. In effect, my 7513 will have five 192.168.101.222 interfaces.
I cannot change anything on, or add anything to, the development networks. I can do whatever I wish to the admin network.
I need help configuring my router to differentiate between five overlapping networks.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...