I have a segment (10.10.10.0/24) which has two paths to it one is a leased line the other is via a site - site VPN on a Pix. My client devices all use the 10.10.10.1/24 router as the default gateway and a second default gateway of the Pix which is 10.10.10.2/24.
Currently the site - site VPN is not active because I'm afraid of a loop. Will there be any issues with looping? Can I put a static route on R1 to point to the Pix weighted so it is not the preferred route unless the 10.10.10.1 port goes down?
configuring a default static route with a higher administrative distance will cause no problems, nothing will go through the VPN unless the primary route is down. It is actually better to configure the second static default anyway, in order not to have to manually cause the link to fail over...
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...