Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

multiple "ip nat inside source static" with same source-ip?

Hi,

I have a router with multiple nat-outside-interfaces and one inside interface and the following translation:

"ip nat inside source static 10.1.1.1 10.2.2.2"

Now I get another outside interface (Dialer100) for which I should do a translation of my internal host 10.1.1.1 to another address (eg. the one I get assigned by dialer100).

Is this possible to overwrite a static-nat for a special target? (with any route-map or anything else?)

regards,

Chris

2 REPLIES

Re: multiple "ip nat inside source static" with same source-ip?

New Member

Re: multiple "ip nat inside source static" with same source-ip?

So I have to make dynamic entries which will work like static ones.

Both sides must be able to start a conversation to the address? Is this possible and how?

regards,

Chris

149
Views
5
Helpful
2
Replies
CreatePlease to create content