Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Multiple Summary Addresses on Interface

Because of a merger between my network and another my IP addresses are not contigous anymore.I am using EIGRP as my routing protocol and my question is can I enter more than one summary address on an interface? This sites has the addresses range from 10.11.0.0-10.16.255.255, can I do the following:

ip summary-address eigrp 1 10.8.0.0 255.252.0.0

ip summary-address eigrp 1 10.12.0.0 255.252.0.0

ip summary-address eigrp 1 10.16.0.0 255.252.0.0

1 ACCEPTED SOLUTION

Accepted Solutions
Community Member

Re: Multiple Summary Addresses on Interface

Yes, you can do that. Multiple summary addreses are supported on a single interface.

One thing you might want to watch is your last summary route - it includes more address space then you said they have. You may want to summarize this way:

ip summary-address eigrp 1 10.8.0.0 255.252.0.0

ip summary-address eigrp 1 10.12.0.0 255.252.0.0

ip summary-address eigrp 1 10.16.0.0 255.255.0.0

I just try to be as accurate as possible with this stuff.

-Mark

1 REPLY
Community Member

Re: Multiple Summary Addresses on Interface

Yes, you can do that. Multiple summary addreses are supported on a single interface.

One thing you might want to watch is your last summary route - it includes more address space then you said they have. You may want to summarize this way:

ip summary-address eigrp 1 10.8.0.0 255.252.0.0

ip summary-address eigrp 1 10.12.0.0 255.252.0.0

ip summary-address eigrp 1 10.16.0.0 255.255.0.0

I just try to be as accurate as possible with this stuff.

-Mark

691
Views
0
Helpful
1
Replies
CreatePlease to create content