Multiple t1's

[tomboydston]

I have a 2651 router and I would like to connect 4 t1's. 2 of them to be used by 1 ethernet port and 2 used on the other ethernet port. I am not sure how to configure this.

Any help would be appreciated

TomB

[olorunloba]

Please, your requirement is not too clear. You will normally connect the T1 to WIC-1T or 2T, not ethernet port. What exactly do you wish to achieve

[tomboydston]

I have a 2651. I want to install 4 T1s on it. I want to use 2 T1s for our division only,and use the other 2 T1s for the rest of the office complex. I want do this by utilizing the 2 ethernet ports if I can. Or is there a better way to do this.

Tom

[dinekal]

Hi,

I would like to suggest PBR(Policy Based Routing).

Hope this URL would address your issues.

http://www.cisco.com/warp/public/cc/techno/protocol/tech/plicy_wp.htm

Good Luck

Dinesh

[sagia]

you have to provide detailed info. what kinda DCE equipment you use.. is it G703 or V.35..? how come you connect WAN DCE cable directly convert to ethernet port..?

please specify..?

mic