Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Multipoint to point-to-point

Hi,

I have a serial interface configured like this:

interface Serial3/1

ip address 192.168.112.100 255.255.255.0

encapsulation frame-relay

frame-relay interface-dlci 143

frame-relay interface-dlci 146

frame-relay interface-dlci 151

and I´d like to set it like this:

interface serial 3/1.143 point-to-point

frame-relay interface-dlci 143

ip address 192.168.1.1 255.255.255.252

interface serial 3/1.146 point-to-point

frame-relay interface-dlci 146

ip address 192.168.1.5 255.255.255.252

interface serial 3/1.151 point-to-point

frame-relay interface-dlci 151

ip address 192.168.1.9 255.255.255.252

Is this simply a matter of re-configure the router or do I have

to ask my Frame relay provider to change something in the cloud?

thank you

edson

2 REPLIES
Silver

Re: Multipoint to point-to-point

You can make this change without any help from your provider.

Thanks.

New Member

Re: Multipoint to point-to-point

You will have to keep the encap frame-relay command on the real interface s3/1. And you will have to remove the dlci statements from the real interface before applying them to the subinterfaces.

No the frame provider will not have to change anything.

89
Views
0
Helpful
2
Replies