Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NAM card VLAN settings - how to change VLAN ?

My customer has a 6509 with a NAM card in slot 9.

If you do a 'sh vlan' for vlan1, ports Gi 9/1 to 9/5 are in vlan1.

From the switch console if you try to change to the port in conf t mode, you get

'This mode not available for these ports'

Is it possible to change the vlan of the NAM 'virtual' ports, and if so how ?

Ian

1 ACCEPTED SOLUTION

Accepted Solutions
Blue

Re: NAM card VLAN settings - how to change VLAN ?

What is the NAM model?. Is the 6509 running CatOS or IOS/NativeIOS?.

If this is a NAM-1/2, then for CatOS, you do not need to configure a VLAN as the NAM management port because that port automatically synchronizes to the VLAN assigned to interface sc0 on the supervisor engine. Note: You cannot set the NAM management port VLAN with the set vlan mod/port command.

If this is NativeIOS, then to configure a VLAN for the NAM management port, you must use the analysis module mod_num management-port access-vlan vlan_id command.

If this is the old WS-X6380-NAM, then for CatOS, then same as above. You do not need to configure a VLAN as the NAM management port because that port automatically synchronizes to the VLAN assigned to interface sc0 on the supervisor engine.

For NativeIOS, you must configure a VLAN for the NAM management port using the switchport access vlan vlan-number command. This is only if the NAM is running 2.x and earlier code. For 3.x and later, the command is analysis module mod_num management-port access-vlan vlan_id

2 REPLIES
Blue

Re: NAM card VLAN settings - how to change VLAN ?

What is the NAM model?. Is the 6509 running CatOS or IOS/NativeIOS?.

If this is a NAM-1/2, then for CatOS, you do not need to configure a VLAN as the NAM management port because that port automatically synchronizes to the VLAN assigned to interface sc0 on the supervisor engine. Note: You cannot set the NAM management port VLAN with the set vlan mod/port command.

If this is NativeIOS, then to configure a VLAN for the NAM management port, you must use the analysis module mod_num management-port access-vlan vlan_id command.

If this is the old WS-X6380-NAM, then for CatOS, then same as above. You do not need to configure a VLAN as the NAM management port because that port automatically synchronizes to the VLAN assigned to interface sc0 on the supervisor engine.

For NativeIOS, you must configure a VLAN for the NAM management port using the switchport access vlan vlan-number command. This is only if the NAM is running 2.x and earlier code. For 3.x and later, the command is analysis module mod_num management-port access-vlan vlan_id

New Member

Re: NAM card VLAN settings - how to change VLAN ?

Thanks,

it is running IOS v12.2.14 SX1

The 'analysis module mod_num management-port access-vlan vlan_id' command should do the trick.

For others looking at this thread, it is found at :

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/cfgnotes/78_14487.htm#56187

Rgds,

Ian

369
Views
5
Helpful
2
Replies