Using the NAM and the ART tool. I use the default settings. I am spanning a VLAN with 200 plus workstations, but when using the ART I only see about 12 or 15 of those workstations reported. If I use a NA Sniffer ART on the same span setttings, I see hundreds of workstations in the reports.
Is there a bug in the NAM software or did I miss a radio box in the set up?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...