I am using a nat on my 2610 router for our internet connection and i have defined a dynamic nat pool of 4 global ip addresses. My problem is only 4 wkstations are connected at a time and I have to clear ip nat translations to allow other users to access the internet. How can I configure my router so that all wkstations are able access the internet concurently?
And sometimes what happens is that i am unable to browse the outside websited except those that are directly connected to my isp. And I tend to wonder whether my routing configuration are some how wrong or whether my isp is getting it wring. But my isp has a static routing protocol directing all the traffic to my network number and the configuration is like this
ip route (my_network_number netmusk MY_router_internet_Interface) interface)
but when I involked the command u advised, it worked for multiple concurrent connections. I dont know how to go about the other problems
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.