Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

NAT and Access list

I use one cisco router to connect remote users (dialers) to the company network (private LAN) and to the Internet via one Leased line.

I want to use NAT to keep my private IP adressing. But I want to allow only some remote users to access the internet.

Can I immplement both of NAT and Access List in the same router ?

Thank you in advance

My email is : wadjinny@hotmail.com

1 REPLY
Cisco Employee

Re: NAT and Access list

YES...You can do both..You can assign the privet address to the dialin users (dialers) and do PAT on the ip address of the outside interface (interface on which the leased line is terminated) for some users while they tries to go on the internet.

You can define those "some users" to do NAT/PAT using the access list command.

Here is the place to start the config.

http://www.cisco.com/warp/public/556/12.html

296
Views
0
Helpful
1
Replies
CreatePlease to create content