I'm having issues using MSN and netmeeting with NAT setup. I'm my router I configured overload or PAT. Where users from the 10.x.x.x network get NAT'ed to single IP address. Any one help me with suggeation or solution to solve this issue.
Below is NAT configuration
ip nat pool OVERLANDPARK 22.214.171.124 126.96.36.199 netmask 255.255.255.240
ip nat inside source list 7 pool OVERLANDPARK overload
ip nat inside source static 10.100.66.15 188.8.131.52
ip nat inside source static 10.100.66.20 184.108.40.206
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...