I have wan(bri using ddr) with 2 2600 series routers with a collection computer on the Lan receiving data from a switch over ISDN. The switch delivering the data send it specially to that pc address. As is the application works no problem; however what I need to do is remove this computer and bring it to a remote site maintaining the same network settings with a 1601 router using analog phone lines to connect over serial line to another router on the same LAN to get connectivity all the way back to the switch. My question will any of the options do it for me (nat/ bridge) and how . Welcome any suggestions.
From what you've described, you might be able to translate your source address once you move it to the different LAN segment, but it doesn't sound like bridging your traffic will accomplish what you're trying to set up. Here's a good starting point for setting up NAT:
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...