NAT for loopback interface in the same router

[jolmo]

Is it possible to do NAT inside-to-ouside for the IP address of a loopback interface of a router ?

Even more, can I use route-maps with this NAT ?

NOTE: This loopback interface is used for DLSw connections.

Thanks in advance

[sbilgi]

1) You can use NAT on the loopback interface of the router .

2) The following link gives you how to configure Route Maps with Static NAT. http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122t/122t4/ftnatrt.htm#wp1021949

[jolmo]

Thanks, I've already tested in a lab environment and it works.