Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAT, multiple interfaces

I am looking for a config example of NAT same source, out two different interfaces.

E0 - 10.10.1.x

E1 - 192.168.1.x

E2 - 2.4.6.x

Need to NAT traffic from source E0 out both interfaces using two pools.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: NAT, multiple interfaces

Hope this helps!

int e0

ip nat inside

int e1

ip nat outside

int e2

ip nat outside

access-list 101 permit ip 10.10.1.0 0.0.0.255 192.168.1.0 0.0.0.255

access-list 102 permit ip 10.10.1.0 0.0.0.255 2.4.6.0 0.0.0.255

ip nat pool first prefix-length

ip nat pool second prefix-length

ip nat inside source list 101 pool first

ip nat inside source list 102 pool second

ip nat inside source

1 REPLY

Re: NAT, multiple interfaces

Hope this helps!

int e0

ip nat inside

int e1

ip nat outside

int e2

ip nat outside

access-list 101 permit ip 10.10.1.0 0.0.0.255 192.168.1.0 0.0.0.255

access-list 102 permit ip 10.10.1.0 0.0.0.255 2.4.6.0 0.0.0.255

ip nat pool first prefix-length

ip nat pool second prefix-length

ip nat inside source list 101 pool first

ip nat inside source list 102 pool second

ip nat inside source

103
Views
5
Helpful
1
Replies
CreatePlease login to create content