Hi, I need to convert the same IP to two different IPs depending on destination address of packet.
I've tested two "ip nat outside source ...", each one with a route-map that test the destination address, but in the first packet natted com dest address X,for example, a NAT's entry is created and after that, even the packet is sent to dest address Y, the entry created before is used not regarding the destination address. Some ideas ?
I tried to use route-map to match destination IP in order to convert to right address, however when I use in inside side, the NAT table uses number ports, so I have problem when the packtes come from outside, in the other way around, using route-map in outside, the NAT table doesn't use ports number, so the route-map didn't work out, the first that is actived is used forever.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.