Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAT on 6506

I am trying to configure NAT on my internal network on a 6506 with the MSFC2 installed. I want to translate the IP address of one of my servers on VLAN 1 to an IP address on VLAN 40. I just can't seem to get it right. I have configured NAT on both my PIX and 1600 series routers with no problem. What is the difference?

1 REPLY

Re: NAT on 6506

Often times complex configuration issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

289
Views
0
Helpful
1
Replies