Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NAT on 6509 with a twist

Currently I have a remote site that has an internal ip address of 192.168.1.0/24. There are a few clients from this net that connect to our HQ using VPN client software and terminate on a PIX 501. The problem is they need to connect to boxes that are on a HQ internal network of 192.168.1.0/24. So for a quick fix we droped in this PIX 501and placed the inside interface on a vlan with an address of 172.24.8.129/26 ( connects to a 6509) The VPN clients send to 172.24.8.66 & 65 then on the vlans we NAT them over to 192.168.1.5 & 7 address. I want to migrate our remote site connections like this: I have a remote site with some users connecting with VPN client software to a PIX 525 at our HQ. The internal IP of the remote network is 192.168.1.0/24, the problem is the network that they need to connect with internally at HQ is also 192.168.1.0/24. The PIX 525 connects to a 6509 and we have multiple VLANs off of this which holds the HQ internal 192.168.1.0/24. Re-addressing is not an option for now. I need help on how to setup NAT on the 6509. It has MSFC & PFC not 2. I hand out 172.22.4.1/24 to the clients when they connect over the VPN. However as you can see the 192.168.1.0 will not route off net. Any Ideas would be a great help!!

1 REPLY
Bronze

Re: NAT on 6509 with a twist

107
Views
0
Helpful
1
Replies