Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAT on a 6506/MSFC 2

I have a GRE tunnel coming into Vlan 60 using public addresses. I also have a private addressed vlan 1 (Management Vlan)on 10.0.0.0 255.0.0.0. I have used simple static NAT to MAP the private/public address for all my network devices. The above configuration is on both 6506/MSCF 2's. I place the NAT Inside config on the interface Vlan 1 and NAT outside on interface Vlan 60. The only way I could get the NAT to work was to place a static route pointing to Vlan 60. The routing table then picked up the route via the other 6506 or I could have used an Interface address on the other 6506, but this is no good as if one 6506 goes down their is no route to the NAT addresses? Surly there must be a confuration where the primary 6506 can deal with the traffic without trying to go via the other 6506(secondary switch)?

3 REPLIES
Silver

Re: NAT on a 6506/MSFC 2

I can't follow you on this one. Please provide your requirements, current configuration and if possible a simple diagram.

Why is it you want to tunnel traffic between both MSFCs? What is the requirement for NAT?

--Leon

New Member

Re: NAT on a 6506/MSFC 2

Leon

Will get info to you.

John

New Member

Re: NAT on a 6506/MSFC 2

Leon

Will get info to you.

John

259
Views
0
Helpful
3
Replies
CreatePlease login to create content