Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NAT on a destination address

I'm using a FWSM on a CAT 6509 and I need to configure static nat on a destination address. That is, if host A wants to speak to host B then host B adress is translated to host C. I need to do this to reslve an overlap issue.

  • Other Network Infrastructure Subjects
3 REPLIES
Purple

Re: NAT on a destination address

Try this (substitute with correct interfaces):

interface ethernet0

ip nat inside

!

int serial0

ip nat outside

!

ip nat outside source static

!

ip route Serial0

!

Hope that helps - pls rate the post if it does.

Paresh

New Member

Re: NAT on a destination address

This config is ok on a router but i'm using a FWSM on a 6509 switch where the interfaces are not as explicitly defined.

Purple

Re: NAT on a destination address

Could you post the relevant bits of your config ?

Paresh

112
Views
0
Helpful
3
Replies
This widget could not be displayed.