I am using ip nat inside source list 102 interface Dialer2 overload
to nat source adress on all outgoing packets. This works fine, but in addition I alsow wants to perform a destination NAT on all packets that cames from 192.168.4.1 and are sent to 192.168.7.1. This packets shuld be sent to 192.168.5.10, with the source adress natet with IP from Dialer2.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...