I have a 2600 with a Public IP configured on the Ethernet Interface. Is it possible to NAT another public IP to a private IP on the same Ethernet Interface or does this require two Ethernet Interfaces? In addition, what would the proper config look like to accomplish the above?
The purpose of the NAT is to enable a separate VPN Tunnel for the VPN 4.x clients to connect and then be able to route through an existing site-to-site VPN tunnel on the "Outside" Interface of the same Pix.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...