04-02-2006 12:03 AM - edited 03-03-2019 02:36 AM
is there any facility to configure NAT like this.
two networks having 192.168.1.0/24 address.
I want to translate like this.
192.168.1.0/24 to 192.168.2.0/24
that means 192.168.1.1 becomes 192.168.2.1
and 192.168.1.2 becomes 192.168.2.2 and so on consecutively................
is there any such one-to-one NAT for ranges mapping facility?
Regards
skrao
Solved! Go to Solution.
04-02-2006 03:29 AM
Yes, there is such a facility and it's called static network translation. You would configure it as such:
ip nat inside source static network 192.168.1.0 192.168.2.0 /24
With the above config, 192.168.1.1 becomes 192.168.2.1, 192.168.1.2 becomes 192.168.2.2 and so on....
Pls do remember to rate posts.
Paresh
04-02-2006 03:29 AM
Yes, there is such a facility and it's called static network translation. You would configure it as such:
ip nat inside source static network 192.168.1.0 192.168.2.0 /24
With the above config, 192.168.1.1 becomes 192.168.2.1, 192.168.1.2 becomes 192.168.2.2 and so on....
Pls do remember to rate posts.
Paresh
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: