07-08-2003 03:47 AM - edited 03-02-2019 08:41 AM
Configuring NAT:
Ip nat inside source list 1 pool my_pool overload
What means keyword OVERLOAD????
07-08-2003 04:00 AM
It means that you do a PAT.
Many ip-addresses sharing one on the outside. Just mapping to different ports.
07-08-2003 04:01 AM
Hi
Means it's not a 1:1 relation.....so you can have many internalt host be nated
to one or a few ip's.
Hope that helps
Roger
07-08-2003 04:01 AM
The Overload keyword allows multiple NAT entries to be mapped to a single IP address by using a unique port to identify the flow. In your example this has been applied to an address pool, this will allow each IP address in the pool to be used for multiple translations instead of the one for one mapping that would occur without it
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: