Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

NAT/PAT query

Hi all.

Strange one: I am backhoming traffic from all of my customer's locations to a central location. When traffic going out to the public internet on port 80 arrives at that central location, I would like it to be redirected to another server on port 8080 before it goes out.

ex:

traffic from any:any to www.yahoo.com:80 should be redirected to 192.168.1.2:8080

This _must_ be transparent for the client machines. I'm using a c1720 v.12.2 IPSec

any suggestions on how to do this are very welcome :)

thanks

-matt

1 REPLY

Re: NAT/PAT query

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

104
Views
0
Helpful
1
Replies
CreatePlease to create content