Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAT pool being used for local traffic

Why, when I do a "show ip nat translation", do I sometimes see a local inside address and a local outside address, but no port numbers (I am running overload) and no global inside or outside addresses? NAT usually runs correctly, but every once in a while, when this does occur, it takes up hundreds of lines in the NAT list. Any ideas on what is happenning and how I can prevent it?

1 REPLY
New Member

Re: NAT pool being used for local traffic

I remember a bug I think. Try Bug Toolkit on Cisco’s web. Pretty sure it’s cosmetic.

109
Views
0
Helpful
1
Replies
CreatePlease login to create content