Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NAT problems.

I configured basic NAT for a 1700. When I go and run

show ip nat trans I see outside & inside local and global transactions in the form of icmp and udp only - no tcp connections. Like I said b/4 I placed basic NAT&PAT statements so I could rule out NAT&PAT. The users can ping everything they desire but Internet Explorer times out. Should I focus on something else or does this seem to be a NAT/PAT problem. I also just have one access-list statement

access-list 1 permit 10.0.0.0 0.0.0.255 to let everyone and everything out(this is the only one that exists).

  • Other Network Infrastructure Subjects
2 REPLIES

Re: NAT problems.

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

New Member

Re: NAT problems.

Hi,

Can you pls paste the Nat Configuration and also the outside interface conf.

Thanks

104
Views
0
Helpful
2
Replies
This widget could not be displayed.