Good Day All !I have Static NAT configured on my C7206, is there any command to check, the current processor utilization by the NAT process ?Though we get to see the `IP NAT AGER` when the `show processes cpu` is executed, it shows a value of `0`, more over i am to understand the `Ip nat ager` process tells us the nat aging time.Any help in this regard would be highly appreciated.Mahe
show processes cpu should give you an accurate count of cpu utilization by any process. It could be zero currently because the process simply isn't running--I htin kthe nat ager is a periodic process, and may not take much time to run, so you'd have to run the show command at just the right moment to see any utilization.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...