07-24-2003 07:20 PM - edited 03-02-2019 09:07 AM
I'm setting up 2611 for NAT-PT with IOS12.2(13)T5.But I can not find "nat" parameter after "ipv6" command.How can I configure NAT-PT ??
07-25-2003 08:51 AM
First you need to enable ipv6
ipv6 enable
and then you will have access to all the commands:
Here is a helpful link:
Eduardo
07-27-2003 03:36 PM
Thanks for your info !
I'm gonna try it.
Tomohiro
08-04-2003 05:54 PM
I did try that command.But "ipv6 nat" is not appeared yet. Someone knows something ??
08-05-2003 12:04 PM
Which IOS version are you running????
08-05-2003 12:07 PM
Sorry, missed your first message. That is why. NAT-PT is no supported by 12.2(13)T5 for the 2611.
08-05-2003 12:11 PM
You can upgrade to 12.2(15)T5 Enterprise Basic
or down grade to 12.2(13)T4 Enterprise Basic. and it will work.
08-05-2003 06:14 PM
Thanks a lot ! I'm gonna try it again.
08-06-2003 12:21 AM
I did upgrade to 12.2(15)T5 and try nat-pt again,but the parameter"nat" is not appeared yet.Do you have any idea ??
08-07-2003 05:33 PM
Please try "IOS 12.3(1a)with enterprise".
Apply the command: ipv6 uni-routing
NAT syntax: ipv6 Nat x x x
For further search, url: http://www.cisco.com/ipv6
08-07-2003 10:04 PM
OK,I'm gonna get the IOS and try again.Thanks !!
01-20-2011 06:03 AM
hi,
yes this is a dead link.
Regards.
Alain.
01-27-2011 06:01 PM
This thread is seven years old. RFC 4966 obsoleted NAT-PT, anyway.
The equivalent information can be found by searching Cisco.com for "NAT-PT feature Guide." But again, there are much better things than NAT-PT in this modern era.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: