Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

NAT-PT

I'm setting up 2611 for NAT-PT with IOS12.2(13)T5.But I can not find "nat" parameter after "ipv6" command.How can I configure NAT-PT ??

12 REPLIES
New Member

Re: NAT-PT

First you need to enable ipv6

ipv6 enable

and then you will have access to all the commands:

Here is a helpful link:

http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide_chapter09186a00801179e2.html

Eduardo

New Member

Re: NAT-PT

Thanks for your info !

I'm gonna try it.

Tomohiro

New Member

Re: NAT-PT

I did try that command.But "ipv6 nat" is not appeared yet. Someone knows something ??

New Member

Re: NAT-PT

Which IOS version are you running????

New Member

Re: NAT-PT

Sorry, missed your first message. That is why. NAT-PT is no supported by 12.2(13)T5 for the 2611.

New Member

Re: NAT-PT

You can upgrade to 12.2(15)T5 Enterprise Basic

or down grade to 12.2(13)T4 Enterprise Basic. and it will work.

New Member

Re: NAT-PT

Thanks a lot ! I'm gonna try it again.

New Member

Re: NAT-PT

I did upgrade to 12.2(15)T5 and try nat-pt again,but the parameter"nat" is not appeared yet.Do you have any idea ??

New Member

Re: NAT-PT

Please try "IOS 12.3(1a)with enterprise".

Apply the command: ipv6 uni-routing

NAT syntax: ipv6 Nat x x x

For further search, url: http://www.cisco.com/ipv6

New Member

Re: NAT-PT

OK,I'm gonna get the IOS and try again.Thanks !!

Purple

Re: NAT-PT

hi,

yes this is a dead link.

Regards.

Alain.

Don't forget to rate helpful posts.
Cisco Employee

Re: NAT-PT

This thread is seven years old.   RFC 4966 obsoleted NAT-PT, anyway.

The equivalent information can be found by searching Cisco.com for "NAT-PT feature Guide."  But again, there are much better things than NAT-PT in this modern era.

466
Views
0
Helpful
12
Replies
CreatePlease to create content