Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAT Static Translations (what is the destintaion command used for?)

i have seen a lot of "ip nat inside source" commands, but no "ip nat outside source" or "ip nat inside destination", i know that "ip nat inside source" is used to make internal services available to the public. what are the other commands used for?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: NAT Static Translations (what is the destintaion command use

ip nat inside source - changes sources addrss of pkts from inside to outside. (or destination address of packets going from outside to inside)

ip nat outside source - changes destination address of pkts going from inside to outside. ( or source add of pkts going from outside to inside)

ip nat inside destination - Usually used in Round robin loadbalancing (TCP load balancing with NAT). Once you configure this command, it can used tochange the destinationa address of pkts coming from outside to inside, and map it on a round robin basis to one of the local private address.

1 REPLY

Re: NAT Static Translations (what is the destintaion command use

ip nat inside source - changes sources addrss of pkts from inside to outside. (or destination address of packets going from outside to inside)

ip nat outside source - changes destination address of pkts going from inside to outside. ( or source add of pkts going from outside to inside)

ip nat inside destination - Usually used in Round robin loadbalancing (TCP load balancing with NAT). Once you configure this command, it can used tochange the destinationa address of pkts coming from outside to inside, and map it on a round robin basis to one of the local private address.

97
Views
0
Helpful
1
Replies