I have an Issue with nat..Its like this one of the machine( say 10.1.1.1 ) needs to go to internet with IP address say ( X.X.X.X) and to some military sites by IP address say ( Y.Y.Y.Y )...how can i achieve this NATing using accesslist or routemap's
This is indeed very tricky as i cant decide to go with static or dynamic NAT...please advise ASAP
I think what you require is PBR (Policy Base Routing),
Here's a example to get you going --
Ip policy route-map
>ip policy route-map map
>no ip policy route-map map
The above configures policy routing.
The above cmd enables policy routing for an interface, basically, policy routing means using criteria other than the shortest path ( as done by a routing protocol) for route selection.
The map parameter is the name of a route map that specifies the routing policy. The map applies only to traffic arriving on the interface.
Here is a example:
The configuration applies the route map MAP1 to packets arriving on the serial1 interface. This route map selects packets that match access-list 101 and sends them to router at 10.1.1.1 for further routing, regardless of other information in the routing table.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.