Yes, this is possible, presuming that the assigned Internet adress on both routers remains the same. Outgoing NAT with overload is not the problem, to direct the incoming traffic to the correct destination is. You have to define a static translation on both sides for this to make session-establishment from both sides possible. As you are using overload PAT you will have to assign a port number for this. To make specific applications work, you need to know at which port number they are attempting to connect.
Use the -ip nat inside source static- command to define this translations.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.