Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAT

HOW CAN WE CONFIGURE NAT FOR CISCO 805 ROUTER, IN WHICH ROUTERS SERIAL INTERFACE GETS DYNAMIC IP FROM ISP.

CAN WE SHARE DAILUP CONNECTION.

1 ACCEPTED SOLUTION

Accepted Solutions
Purple

Re: NAT

You can do something like this:

int ethernet 0

ip nat inside

!

int serial0

ip nat outside

!

ip nat inside source list 1 interface serial0 overload

!

access-list 1 permit 10.0.0.0 0.255.255.255

(change this to match your LAN network)

Pls do remember to rate posts.

Paresh

3 REPLIES
Purple

Re: NAT

You can do something like this:

int ethernet 0

ip nat inside

!

int serial0

ip nat outside

!

ip nat inside source list 1 interface serial0 overload

!

access-list 1 permit 10.0.0.0 0.255.255.255

(change this to match your LAN network)

Pls do remember to rate posts.

Paresh

New Member

Re: NAT

Shall I give dns server ip of the ISP to all machines in the LAN.

I have tried giving routers LAN interface ip address as dns to all pcs but didnt work.

But iam able to ping internet ips from all pcs.

Purple

Re: NAT

Yes, I would use the public DNS server IP of the ISP to your LAN hosts. The alternative is to create a static NAT translation for it but it will work just as well if you used the un-translated address...

Pls do remember to rate posts.

Paresh

97
Views
8
Helpful
3
Replies
CreatePlease login to create content