Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

NATTING

When using Nat on a router, Can you Nat any traffic that comes in, i.e if I have a router with a lan address of say 10.1.1.0 etc, could I nat say some 172.24.56.0 traffic that comes into the router ?

2 REPLIES

Re: NATTING

hi

You can try using ip nat outside source command where u will nat the outside source addres.

do refer this link for more info and the usage options/keywords..

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/ipras_r/ip1_i2g.htm#wp1079462

The below link inturn will throw more lite on a similar scenario..

http://www.cisco.com/warp/public/556/2.html

regds

New Member

Re: NATTING

So is this the normal scenero for doing this, and I gather the outside interface doesnt need to be on the same subnet as whatever addresses you are natting ?

113
Views
0
Helpful
2
Replies
CreatePlease to create content