Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

natting

When we do static nat translations on a router say we do 10.1.1.2 in to 192.168.1.2 out, what would the route be to reach this network would it be say on the other router ip route 192.168.1.0 255.255.255.0 192.168.1.1 ?

Also if we used Eigrp and natted on the same router, what networks would you need to advertise ?

thanks

2 REPLIES
Silver

Re: natting

Hi,

Your are going to use static route on the other router which is connected thro. outside interface, so that u have to use natted ip of that interface in destination address....

In the second case also u have to announce only natted subet in eigrp

Rate if it does,

Rgs

New Member

Re: natting

would that be the inside or outside natted subnet ? and would I route by pointing the 192.168.1.0 network to 192.168.1.1 ?

thanks

Carlos

100
Views
0
Helpful
2
Replies
CreatePlease login to create content