Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

natting

when I nat, does the outside interface have to be on the same ip range as what ive natted my internal clients too, or does it not matter ? and would I just point the from say another the natted addresses to the ip address of the nat router ?

1 REPLY

Re: natting

Hi Carl,

AFAIK when you have to go to internet it really matters that you should nat with an ip which your ISP have alloted to you (now your isp will allot you an ip and that ip will definetely be configured on your outside interface) or else you will not be able to move into ISP network.

Now lets say you are just moving around in your private network then as per me it really does not matter which ip pool range you used to NAT with while moving the packet out of outside interface but you need to have a specific route for that packet on another router to point the traffic back to the outside interface of the natted router.

HTH, if yes please rate the post.

Ankur

93
Views
0
Helpful
1
Replies
CreatePlease to create content