Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NBAR and 6500-PFC3-720

In CISCO docs, I read that with 6509-Sup720, NBAR is not supported, but on my 6509 I am able to configure NBAR and 'sho ip nbar proto ' gives me proper output. I m confused. Could someone clarify ?

IOS: 12.2(17d)SXB10

Supervisor Engine 720 (Active) WS-SUP720-BASE fw=8.1(3) sw= 12.2(17d)SXB

to0#sho ip nbar proto top

Vlan2

Input Output

Protocol Packet Count Packet Count Byte Count Byte Count

5 minute bit rate (bps) 5 minute bit rate (bps)

------------------------ ------------------------

netbios 14847335 7245179

14896976857 3800223115

16000 490000

...

1 REPLY

Re: NBAR and 6500-PFC3-720

Hi,

I do not know which documentation you are refering to, but NBAR on Cat6500 Sup720 is supported since CatOS 8.1 and since I think IOS 12.1E but definately in all 12.2 versions.

So don´t worry you didn´t find the magic command, everything is as it should be.

Hope this helps

Martin

233
Views
0
Helpful
1
Replies
CreatePlease login to create content