Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

NBAR

Inside a Class map you can match on protocol RTP [ Audio | Video ]

To use the flag Audio or Video do you need to habe NBAR running ????

per

2 REPLIES

Re: NBAR

Hello,

once you configure "match protocol" you are already using NBAR. It is not needed to use NBAR protocol-discovery though, if this was your assumption.

Hope this helps! Please rate all posts.

Regards, Martin

Re: NBAR

hi

you need to have protocol-discovery enabled once before you start using protocols based on their names like (RTP etc.,).

once you have enabled the same and remove the command the whole protocol entries remains intact even after a reload.

We have checked out the same in an lab scenario quite sometime back...

regds

121
Views
0
Helpful
2
Replies
CreatePlease to create content