I have the following scenerio I desperately need a solution for.
I have a long haul T1 link. I need to bring this T1 into a device. At this device I need to share this T1 to two internal customers. I need to map 20 Ds0's of the T1 to a internal port and specify B8ZS/ESF. I need to map 4 of the DS0's to another internal port and specify AMI/D4. Both internal devices are utilizing these DS0's for voice, so a data type signal (IE RS449, RS530) is not an option. The devices need to see channelized TDM type signaling.
Can any of you recommend a Cisco device that will do this?
We had a Quickeagle DL100 T1 multiplexer attempting to do this but it only has one internal port that provides the direct type TDM signaling. The other ports were data ports (RS449) and would not work.
I believe Cisco make NM-CE1T1-PRI will do for u along with a router say Cisco 2621XM.
On that you can configure the timeslots as required.The beauty of this is a serial interface will pop up for each timeslots range.So you can route packets.This will be as good as working with 2 serial lines.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.